Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateTrusted Heating & Furnace for Enterprise Homeowners
Most furnace failures in Enterprise don’t announce themselves politely. One cold January morning the blower runs but the air comes out cool, or the burner fires for 90 seconds and shuts down, and you’re standing in the hallway trying to remember what the last guy actually fixed. We’ve been doing this work in the Las Vegas Valley for over 29 years, owner-operated since 2002, and our technicians have up to 24 years of experience with your make and model. Ray answers the phone himself. We test before we quote, and we don’t leave until the heat is coming out the way it should.
Call (844) 455-2034 for a free estimate, and same-day service in Enterprise whenever the schedule allows.
What Our Heating & Furnace Service Includes
Furnace Repair
Furnace repair is the work of finding out why your system stopped making heat and fixing that specific thing. It could be a limit switch tripping on a 40-degree night, a flame sensor coated in dust, or a blower motor pulling too many amps. We put gauges and a meter on the unit before we say anything. If you’re in Enterprise and your furnace is short-cycling, blowing cold, or making a noise it didn’t make last winter, we can usually get eyes on it the same week.
We work on gas furnaces across all the major brands, and every repair carries the 90-Day Done Right Promise. If what we fixed turns out to be wrong, one call brings Ray back.

Furnace Replacement
A furnace replacement is a big purchase, and the honest answer to “repair or replace” depends on the age of the unit, how often you’ve called us out this season, and the condition of the heat exchanger. We do a load calculation first so the new unit is sized for your house, not for whatever the old one happened to be. Then we give you a written fixed price and a set install date. No surprise line items the morning of.
We handle the paperwork for any rebate or financing you qualify for, so you’re not chasing it down on your own. Expect a two- to four-day turnaround from approval to install.

Furnace Tune-Up
A tune-up is a flat-price visit where we clean, test, and tell you in writing what we actually found. We check gas pressure, flame color, amp draw on the blower, and the condition of the heat exchanger. We also test the capacitor while we’re in there, because a weak capacitor in the summer is often a failed compressor the next year.
The technician is not paid on what they sell. That’s a business decision, not a slogan. You get the readings and the recommendations, and you decide.

Heat Exchanger
The heat exchanger is the metal part that keeps combustion gases separate from the air you breathe. A crack in it is not a maintenance note, it’s a safety issue, and it’s one we take seriously. A cracked heat exchanger can let carbon monoxide into your home. We inspect it with a camera and a visual pass, and if it’s compromised, we tell you straight and give you the repair or replacement numbers.
Never let anyone hand-wave this part of the inspection. If a technician tells you the exchanger is fine, ask them what they saw.
Ignitor Replacement
The ignitor is the hot-surface element that lights the gas when the thermostat calls for heat. When it fails, the burner never lights and the furnace goes through a safety shutdown cycle. We test the ignitor’s resistance and confirm the control board is actually sending voltage before we replace anything. A furnace that clicks repeatedly without firing is a classic sign.
This is typically a short repair, often finished in one visit, and it’s one of the more straightforward fixes on a gas furnace.
Gas Valve Repair
The gas valve controls gas flow into the burner assembly. When it sticks open, sticks closed, or fails to open on a call for heat, the furnace either won’t fire or won’t shut off safely. This is a safety-critical component, and we treat it that way. We test inlet pressure, manifold pressure, and the valve’s response before recommending any replacement.
If the valve is sticking, we don’t try to clean it and hope. We give you a clear price for a proper replacement. Any work on gas lines is done by someone trained for it, and we’d tell any homeowner the same: don’t touch the gas side yourself.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Brands We Service for Heating & Furnace
We service Carrier equipment regularly and know the wear patterns that show up on their older condensing furnaces, particularly around the inducer and the pressure switch tubing. Lennox units we see in a lot of Enterprise homes, and we know the control board quirks on the mid-2000s models well enough to save you a wild-goose-chase diagnostic visit. Trane and American Standard furnaces hold up well, but when their ignitors or flame sensors start to drift, the furnace will let you know with a lockout on cold mornings.
Whether you’ve got Carrier, Trane, Lennox, American Standard, or any other make, we can help. We work on Goodman, Rheem, York, Daikin, and Bryant the same way. No brand gets a shortcut diagnosis.
Signs You Need Heating & Furnace Right Now
- No heat at all. The thermostat is on and set above room temperature, but the blower runs and the air stays cool. This usually means the ignitor, the flame sensor, or the gas valve has failed, and every hour you wait is an hour the house gets colder.
- The burner fires and shuts down. A furnace that runs for 30 seconds to a few minutes and then quits is short-cycling. It could be a blocked flue, a bad limit switch, or a pressure switch issue, and none of those sort themselves out.
- A yellow or orange flame. The burner flame should be crisp blue. Yellow, orange, or lifting flames are a combustion problem and a possible carbon monoxide signal. Shut the unit off and call us.
- Rotten-egg smell near the furnace. That’s the added odorant in natural gas. If you smell it, don’t flip switches, get out, and call your gas utility first, then call us to inspect the furnace once it’s safe.
- Rumbling, banging, or a blower that grinds. These are mechanical sounds, not normal furnace operation. A bearing going bad in the blower motor or debris in the burner can turn a small repair into a big one if you leave it.
If you’re seeing any of these, call (844) 455-2034. We answer around the clock.
Our Heating & Furnace Process – Step by Step
- 1
We listen. When you call, a live person picks up, not a voicemail maze. Ray or the person at your door will ask what the furnace is doing, how old it is, and whether anything changed recently. Those three answers tell us a lot before anyone touches a tool.
- 2
We diagnose before we quote. Readings first, numbers second. We check gas pressure, ignitor resistance, flame sensor microamps, and blower amp draw. If the readings say the blower is fine and the flame sensor is the culprit, that’s what we tell you. We don’t say “compressor” or “control board” until the meters back it up.
- 3
We show you the numbers. Before any work begins, you see the readings and the price. If it’s a repair over $200, the repair is $40 off. Every estimate qualifies for a free second opinion if you want one.
- 4
We fix it, and we back it up. The repair is done by a background-checked technician, and every heating job is stamped with the 90-Day Done Right Promise. If something isn’t right, one call brings us back.
- 5
We follow up. If it’s a replacement, we handle the rebate and financing paperwork and set the install date. If it’s a repair, we make sure the heat is coming out the vents before we drive away.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Heating & Furnace Cost in Enterprise?
Furnace repair in Enterprise typically runs $150 – $700, depending on the part and how deep the diagnostic goes. An ignitor or flame sensor is on the low end; a blower motor or control board is on the high end. A furnace tune-up runs $80 – $200, and it’s the cheapest $80 you’ll spend if it catches a failing component before January.
What moves the number: the age of the unit, whether the part is a stock item or needs to be ordered, and how much diagnostic time it takes to isolate the actual failure. Homes in older Enterprise neighborhoods, especially those with 1990s construction and original ductwork, sometimes turn up a second problem (a cracked heat exchanger or disconnected flex duct) that wasn’t on the original work order. We show you that before we quote it.
How to avoid overpaying: ask what the readings were, ask what part failed and why, and don’t accept “it’s the whole board” without a meter reading to back it up. We give you both on every visit. There’s no trip charge inside Clark County, and the second opinion on any written estimate is free.
Call (844) 455-2034 for an exact quote. Estimates are free.
Heating & Furnace Near Enterprise – Our Service Area
We serve Enterprise and the surrounding valley, including neighbors in Heating & Furnace in Spring Valley and Heating & Furnace in Paradise. Typical response time in Enterprise and Spring Valley is same-day or next-morning; out toward Sandy Valley and Boulder City it’s usually the next available appointment. If you’re searching from your home in any of these areas, we can usually tell you on the phone when the next spot opens.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Heating & Furnace in Enterprise
Heating and furnace service covers everything that keeps your gas furnace running safely and efficiently: repair, replacement, tune-ups, heat exchanger inspection, ignitor replacement, and gas valve work. It’s the full range of work on the heating side of your HVAC system. If your furnace won’t fire, won’t stay lit, or is making a noise that concerns you, that’s what we do.
Most repairs take one visit of one to two hours, depending on the part. Ignitor and flame sensor replacements are usually under an hour. A blower motor or control board replacement can take longer if the part has to be ordered. We tell you the expected time when we confirm the appointment, and we don’t leave until we’ve verified the furnace is producing heat.
Furnace repair in Enterprise typically runs $150 – $700, depending on what failed and how much diagnostic time is needed. A tune-up is $80 – $200, and there’s a $40 discount on any repair over $200. Call (844) 455-2034 for an exact quote. Estimates are free.
Yes, we service Carrier and Trane furnaces, along with Lennox, American Standard, Goodman, Rheem, York, Daikin, and Bryant. Our technicians have up to 24 years of experience, and we know where each of these brands tends to wear out. If you tell us the brand and model on the phone, we can usually bring the right part on the first visit.
Yes, same-day service is often available in Enterprise, especially for a furnace that isn’t producing heat. Call (844) 455-2034 and a live person will pick up, day or night. If the next available slot is tomorrow morning, we’ll tell you that on the call instead of leaving you guessing.
Every heating job carries a written 90-Day Done Right Promise. If the repair isn’t right, one call brings Ray back to make it right, no argument. Parts have their own manufacturer warranties on top of that, and we’ll walk you through what’s covered when we hand over the invoice.
Clear a path to the furnace and the thermostat, and write down anything you’ve noticed (noises, smells, when it started). If you smell gas, leave the house and call your gas utility first, then call us once it’s safe. Otherwise, having the model and serial number ready helps us come prepared.
Schedule Your Heating & Furnace Service in Enterprise Today
If your furnace is short-cycling, blowing cold, or just past due for a tune-up, call (844) 455-2034 and a live person will pick up, day or night. We’ll give you a free estimate, upfront pricing, and same-day service in Enterprise when the schedule allows. Every job carries the written 90-Day Done Right Promise. Check out our Heating & Furnace in Enterprise page for the full scope of work, and we’ll see you at the door.
Written by the team at Ray’s Heating & Air Enterprise.