Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Heating & Furnace Across Henderson
If your furnace quit overnight and the house is cold, call Ray’s Heating & Air Enterprise at (844) 455-2034. We answer live, day or night, and we know Henderson – the Green Valley tracts, the Seven Hills hillside lots, the older 89015 homes near downtown. Desert cold snaps here are short but sharp, so a dead furnace is a problem to fix now, not next week. That’s why we keep the same promise on every Henderson heating job: you see the readings before you see the numbers.
Why Ray’s Heating & Air Enterprise Is Henderson’s Preferred Heating & Furnace Company
Henderson homeowners call us back for one reason: they get the same person at the door, not a rotating cast who’ve never laid eyes on their system. Our technicians have up to 24 years of experience, and every heating job carries our 90-Day Done Right Promise in writing – if it isn’t done right, one call brings us back. That beats a phone quote from an outfit you’ve never met.
We know this city block by block. We can tell you why a furnace in Anthem runs a little harder uphill than the same unit in flat Green Valley, and we know which MacDonald Ranch subdivisions are hitting their replacement window all at once. We serve Henderson and the surrounding towns, and we get to most Henderson addresses within a short drive – often the same day you call. No trip charge inside our own county, and a free second opinion on any written estimate you’ve already got in hand.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Our Heating & Furnace Services in Henderson
Our Heating & Furnace team handles the full range of furnace and heating work here, from a $150 repair to a full replacement that fits the house you actually live in. Here’s where most Henderson calls land.
Furnace Repair in Henderson
Most Henderson furnace calls start as short-cycling or a blower that runs but never warms the far bedrooms. That’s usually a failing ignitor or gas valve sitting on top of undersized or leaky boom-era ductwork. We test the ignition, flame sensor, and gas pressure before we quote anything, and a typical furnace repair in Henderson runs $150-$700.

Furnace Replacement in Henderson
When the original builder-grade furnace in a 1990s or 2000s tract home crosses 15-25 years, replacement is usually the smarter money. But a straight like-for-like swap often disappoints here – the new furnace has to match the ductwork and tonnage the house was built for, or it short-cycles and leaves rooms cold. Replacement is scheduled work: we do a load calculation, give you a written fixed price, and set a firm install date.

Furnace Tune-Up in Henderson
A tune-up runs $80-$200 in Henderson and covers far more than a filter change: gas pressure, flame sensor, ignitor, blower motor, and a heat exchanger inspection. Desert dust loads up components fast during a long cooling season, so an annual check catches wear before a cold snap does. You get a written report of what we actually found.

Heat Exchanger Service in Henderson
A cracked heat exchanger is a carbon monoxide risk, not a repair you put off. Builder-grade furnaces in Green Valley and MacDonald Ranch often show hairline cracks alongside blower motor wear as they age. We inspect the exchanger honestly and tell you straight whether it needs replacement – a cracked exchanger means a new furnace, not a patch.
Trusted Brands We Service in Henderson
We service all the major brands you’ll find in Henderson homes – Carrier, Trane, Lennox, American Standard, Goodman, Rheem, York, Daikin, and Bryant among them. We don’t stock parts on a truck or claim to; what we do is diagnose correctly the first time so the right part gets ordered and installed without guesswork. That covers the 1990s builder units and the newer equipment going into Anthem and Seven Hills.
Common Heating & Furnace Problems We See in Henderson Homes
Here’s what actually shows up on heating calls around here, and why:
- Synchronized equipment failure. Most Henderson heating equipment went in during the 1990s-2000s tract build-out, so neighbors on the same street hit the end of a builder-grade furnace’s life within a year or two of each other. Heat exchanger cracks and blower motor wear tend to surface together.
- Undersized or leaky original ductwork. Boom-era duct runs built for a specific tonnage create high static pressure. Even a correctly sized replacement furnace short-cycles or leaves the far bedrooms cold until the ducts are addressed.
- Cold far rooms in single-zone homes. A single-zone system fighting an unbalanced floor plan in a two-story Anthem or Seven Hills house will always leave one end short. The fix starts with a static pressure and load test, not a bigger furnace.
- Panel capacity on older 89015 homes. Some older electrical panels near downtown Henderson can’t support a modern furnace or heat pump circuit without an upgrade, turning a like-for-like swap into a panel and load calculation job.
See the difference
Before
After
Before
After
Before
AfterWhy a Like-for-Like Swap Often Disappoints in a Henderson Home
This is the part most heating pages skip. In Henderson, a straight equipment swap frequently fails because the house, not the furnace, is the real problem. Take a 1990s Green Valley or MacDonald Ranch house where the blower runs but never warms the back bedrooms. That call is usually a failing ignitor or gas valve combined with original duct runs built for a tonnage the current equipment no longer matches. The correct diagnosis starts with a load calculation and a static pressure test, not a parts swap. A qualified local tech cleans or replaces the flame sensor and ignitor, checks the heat exchanger for cracks, verifies gas pressure at the valve, then confirms the retrofit matches the home’s actual tonnage and duct capacity before recommending replacement. Skip those steps and you’ve paid for a furnace the ductwork can’t feed.
Henderson differs from older central Las Vegas (one-at-a-time retrofits) and from newer hillside custom builds elsewhere, because the replacements here cluster by subdivision. That synchronized aging is why like-for-like sizing decisions get made against ductwork built for a very specific tonnage – and why a panel check comes first in older 89015 homes.
Pricing for Heating & Furnace in Henderson, NV
Honest numbers, upfront. A typical furnace repair in Henderson runs $150-$700 depending on the part and whether ductwork is part of the fix. A tune-up is $80-$200 and includes a written report of what we found. Replacement is quoted after a load calculation, with a written fixed price and a set install date – no phone-quote-then-door-quote games. Prices in Henderson are close to nearby markets; the real variable is your house’s ductwork and panel, not the zip code. Free estimates, and we’ll give a free second opinion on any written estimate you already have.
We Also Serve Cities Near Henderson
If you’re just outside the Henderson line, we can help there too. We work regularly in Boulder City, Whitney, Paradise, and Enterprise, and the same 90-Day Done Right Promise and live-answered calls apply across all of them. No trip charge inside our own county, so a call from just across the line is still worth making.
Serving Henderson, NV – Our Local Coverage Area
We serve Henderson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Heating & Furnace in Henderson
Because the house, not the furnace, is usually the weak link. Boom-era ductwork in Green Valley and MacDonald Ranch was built for a specific tonnage, so a straight swap that ignores high static pressure and leaky original runs short-cycles or leaves far bedrooms cold. The fix is a load calculation and static pressure test first. Call (844) 455-2034 for a free estimate.
Because most equipment here went in during the 1990s-2000s tract build-out, so neighbors hit the end of a builder-grade furnace’s life within a year or two of each other. That synchronized aging means sizing decisions get made against the same original ductwork. Call (844) 455-2034 and we’ll check where your equipment stands.
Yes. A cracked heat exchanger is a carbon monoxide risk, so it means a new furnace, not a patch. Builder-grade units in Green Valley and MacDonald Ranch often crack alongside blower motor wear as they age. Call (844) 455-2034 for an honest inspection before the cold weather hits.
Because some older panels near downtown Henderson and 89015 can’t support a modern furnace or heat pump circuit without an upgrade. That turns a like-for-like swap into a panel and load calculation job, so we check it first. Call (844) 455-2034 for a free estimate.
A Henderson tune-up runs $80-$200 and covers gas pressure, flame sensor, ignitor, blower motor, and a heat exchanger inspection, with a written report of what we found. Desert dust loads components fast, so it’s worth doing before a cold snap. Call (844) 455-2034 to schedule.
Ready to get your heat handled? Call Ray’s Heating & Air Enterprise at (844) 455-2034 for a free estimate. Live person, every time. If it isn’t done right, one call brings us back.
Written by the team at Ray’s Heating & Air Enterprise.
| Service | Typical Henderson Price |
|---|---|
| Furnace Repair | $150 – $700 |
| Furnace Tune-Up | $80 – $200 |