A Ray's company - serving Enterprise, NV

Lennox Heating & Furnace in Enterprise, NV

Furnace & heatingFurnace & heating
AC repairAC repair
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Lennox Heating & Furnace in Enterprise: What to Know First

We repair and service Lennox furnaces and heating systems in Enterprise as an independent Lennox service provider, and most heating calls here are handled the same week, often the same day when it’s cold. Typical Lennox furnace repair in Enterprise runs $150 to $700 depending on the part, and a tune-up is $80 to $200. You’ll see the readings before you see a number, and that number doesn’t change when the work wraps up.

Call (844) 455-2034

This page is for the homeowner with a Lennox furnace in the garage or closet who has already been handed one estimate and wants a straight second read on it. If your heat is out now, call (844) 455-2034. A live person answers around the clock, including the owner at two in the morning.

How Lennox Products Fail – and How We Fix Them

Lennox builds a good furnace. What goes wrong in Enterprise is usually part-specific and predictable once you know the series. Here’s what we actually see on Lennox equipment in this town:

  • Failed hot surface ignitors on the Elite and Signature series. The ignitor cracks before it quits, so you get a furnace that lights on the second or third try for a week and then doesn’t light at all. Enterprise’s dusty spring air and the vibration from a garage-mounted unit both shorten ignitor life. We test resistance and swap the ignitor – a same-visit repair in most cases.
  • Dirty flame sensors tripping the furnace into lockout on Merit series units. The board reads a weak flame signal and shuts the gas valve on a safety. Nine times out of ten it’s a carboned-up sensor, not a bad board. We clean or replace the sensor and check the signal, which saves you a board you didn’t need.
  • Cracked heat exchangers on older Lennox G-series furnaces. This is the one that matters. A cracked exchanger can push combustion gases into the supply air. We scope it and show you what we see. If it’s cracked, the honest answer is usually replacement, not a patch – and we’ll say so plainly.
  • Sticking gas valves on Lennox units that sit unused through a mild Enterprise winter. The valve gums up from long idle stretches, so the burners light late or short-cycle. We verify inlet and manifold gas pressure with a manometer before anyone touches the valve.
  • Control board and pressure switch faults on Variable Capacity and two-stage Lennox models. These communicate through a board that doesn’t like voltage dips. We check incoming power and the pressure switch before condemning the board, because a $400 board is the wrong first guess.
Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Our Lennox Heating & Furnace Process

Every Lennox job follows the same path, from the first call to the last wipe-down:

  1. 1
    You call and a person answers. Not a phone tree. We ask what the furnace is doing and what model you have, and we set a window.
  2. 2
    We diagnose with readings, not guesses. Gas pressure, flame signal, ignitor resistance, temperature rise, and the flash code off the Lennox board. You see the numbers as we take them.
  3. 3
    We decide OEM versus quality aftermarket together. OEM Lennox parts keep the factory fit and protect your warranty. A quality aftermarket part can save real money when the OEM lead time is long. We lay out both and let you choose.
  4. 4
    We do the repair. Parts that need to be ordered get a firm date, not a “sometime next week.”
  5. 5
    We test the whole furnace, not just the part. A full heat cycle, temperature rise verified, and combustion checked before we call it done.
  6. 6
    We clean up and back the work in writing. The 90-Day Done Right Promise is stamped on the job. If it’s not right, one call brings us back.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Lennox Heating & Furnace Costs in Enterprise

Here’s the honest range for common Lennox heating work in Enterprise. The final number depends on the part, the model, and what we find when we open it up – which is why we quote after diagnostics, not before.

  • Lennox furnace repair: $150 to $700. Ignitors and flame sensors sit at the low end; gas valves, control boards, and heat exchanger work climb toward the top.
  • Lennox furnace replacement: priced per job after a load check, with a written fixed price and the install date set before we start.
  • Lennox furnace tune-up: $80 to $200, flat, with a written report of what we actually found.

What moves the price: OEM versus aftermarket parts, whether the furnace is in a tight closet or a garage, and how far the model is from needing a heat exchanger. Estimates are free, and we’ll give a free second opinion on any written estimate you’re holding. Call (844) 455-2034 for an exact quote.

Why Enterprise Homeowners Call Ray’s Heating & Air Enterprise for Lennox Work

You get the same person at your door who knows Lennox part numbers and flash codes, not a rotating crew who’ve never seen your system. When we say the ignitor’s cracked, you’ll see the crack. Every Lennox job carries the 90-Day Done Right Promise in writing: if it’s not done right, one call brings us back.

We also service Carrier and Trane, so if your house has a mix of brands, one call covers all of it. We’re locally owned and owner-operated, with a published name, address, and license number you can check yourself before we pull into the driveway.

FAQs

Need HVAC help nationwide? Licensed & insured · 1-hour response · free estimates
Call (844) 455-2034
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Ray's Heating & Air Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch