Ductless mini splits
AC repair
Furnace & heating
Heat pumps
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Mini-Split Installation: The Enterprise Owner’s Guide
We install and service Lennox mini-split systems in Enterprise, and a full single-zone install runs $3,500 – $7,500 depending on tonnage, line-set length, and whether we’re adding a dedicated 240V circuit. Multi-zone heads and anything needing panel work land at the top of that. When someone calls us for “install” in Enterprise, though, the real problem is usually not a missing system – it’s an existing one that’s limping.
Here’s the pattern. The outdoor unit starts short-cycling in July. The indoor head blows cool but not cold. There’s ice on the suction line by morning, or a puddle on the tile under the wall unit. Nine times out of ten the compressor is fine and the actual culprit is a failed capacitor, a low refrigerant charge, a blocked condensate drain, or a control board that’s aged out. That’s the part we end up replacing. This page is about matching the right part to your Lennox unit, pricing it honestly, and getting it done before the next 110-degree afternoon.
Which Lennox Models This Applies To
Lennox mini-splits are most commonly seen here as the MS8 and M22 series (single-zone and multi-zone), plus the older MS7 lines still running in homes around Enterprise and the outlying rural properties. The model plate lives on the right side panel of the outdoor condenser – you’ll want the full model number, the serial number, and the tonnage. That plate matters because Lennox changed board revisions and capacitor specs between production runs of what looks like the same unit.
Here’s the compatibility gotcha most homeowners don’t know: the indoor head and the outdoor condenser have to match as a tested pair. A Lennox indoor evaporator swapped onto a mismatched outdoor unit – even one from the same series – can run at the wrong charge and short the compressor life. When we replace a failed part, we’re pulling the pairing spec from the plate, not guessing. The other thing: Lennox OEM boards and capacitors cost meaningfully more than quality aftermarket equivalents, often 30 to 50 percent more. We’ll quote both, tell you what each one is, and let you pick. We’re independent – not affiliated with Lennox – so the recommendation is based on your unit, not a badge. We also service Carrier and Trane systems if you’ve got one of those on the property too.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Lennox Mini-Split Installation Is Failing
- Ice forming on the indoor coil or suction line. Usually a low refrigerant charge or restricted airflow from a clogged filter or blower wheel. Left alone, it stresses the compressor every cycle.
- The outdoor unit won’t start, or clicks then quits. Nine times out of ten this is a failed capacitor, not the compressor – and we test the capacitor before anyone says the word compressor.
- Water pooling under the indoor head. A blocked condensate drain or a cracked drain pan. In Enterprise’s dust and wind, drains clog faster than most people expect.
- Short cycling – runs a few minutes, shuts off, restarts. Could be a control board, a thermostat mismatch, or a refrigerant issue. The readings tell you which; guessing doesn’t.
- Error codes on the remote or indoor display. Lennox codes point to a specific sensor, board, or communication fault. Read the code first, then pull the part.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For part replacement and repair on an existing Lennox mini-split, most jobs in Enterprise land in the $150 – $650 range for AC repair. A capacitor or board swap sits at the low end; a refrigerant leak repair with recharge and a new drain pan pushes toward the top. What drives the spread is the part itself (OEM versus quality aftermarket), whether we’re opening a wall or ceiling chase, and whether the system needs a charge adjustment afterward.
You’ll see the readings and the numbers before any work begins. Parts cost and labor are broken out on the estimate, not buried. Every repair carries our 90-Day Done Right Promise in writing – if it’s not done right, one call brings Ray back. No trip charge inside the county, and a free second opinion on any written estimate you’ve already got. If you’re looking at a full new install instead, AC installation in Enterprise runs $3,500 – $7,500, and we’ll tell you honestly which way the math points once we’ve seen your unit.
DIY or Call Us?
Some of this is safe to check yourself. Look at the model plate. Pull and rinse the indoor filter. Clear visible debris off the outdoor coil. Write down any error code you see. That’s useful diagnostic information, and nobody’s going to get hurt doing it.
What we’d stop short of: opening the electrical panel on the outdoor unit, discharging a capacitor, handling refrigerant lines, or pulling the control board. A charged capacitor holds lethal voltage well after the disconnect is pulled, and refrigerant work requires a license and a recovery setup. In Enterprise’s summer heat, a system down for a week isn’t just uncomfortable – it’s a health risk for anyone older or on medication. If your Lennox is short-cycling, icing up, or throwing codes, call (844) 455-2034. We’ll get out there, take the readings, and give you a straight answer.
FAQs
Capacitors and control boards in our climate commonly give out in 7 to 12 years, with capacitors usually first. Enterprise’s summer heat and dust shorten that. Compressors typically go much longer if the charge stays correct and the coil stays clean.
Sometimes. A board with a failed relay can occasionally be repaired, but on most Lennox mini-split parts the repair costs more than a replacement and doesn’t carry the same reliability. We’ll tell you which way it falls once we’ve seen it. Call (844) 455-2034 for a straight answer.
A capacitor or small sensor swap is often under an hour. A control board or a drain pan replacement runs two to four hours, depending on access to the indoor head. Refrigerant work adds time.
We pull the exact model and serial from your outdoor plate, match the part number to that revision, and order from a supplier we trust. We don’t stock parts on a truck, so expect a day or two for anything not on hand. OEM or quality aftermarket – your call, both quoted.
If your Lennox mini-split is acting up in Enterprise, don’t wait for it to quit on the hottest day of the year. Call (844) 455-2034 for a free estimate. We answer live, 24/7.
Written by the team at Ray’s Heating & Air Enterprise, serving Enterprise and nearby areas.