A Ray's company - serving Enterprise, NV

Lennox Heat Pump & Mini Split in Enterprise, NV

Heat pumpsHeat pumps
AC repairAC repair
Furnace & heatingFurnace & heating
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Lennox Heat Pump & Mini Split in Enterprise: What to Know First

We service and install Lennox heat pumps and mini splits in Enterprise as an independent Lennox service provider, and most repair calls get handled the same day you reach us. Honest pricing on the common repairs runs $150 to $650, and a full heat pump or multi-zone install runs $3,500 to $7,500 – we give you a written estimate before anything gets touched. This page is for Enterprise homeowners who already own a Lennox system and want someone who actually knows the equipment, not a crew reading a manual for the first time. Call (844) 455-2034 and a live person picks up, day or night.

Call (844) 455-2034

How Lennox Products Fail – and How We Fix Them

Lennox builds good equipment, but certain lines have predictable weak points once they’re past the 8- to 10-year mark, especially in Enterprise’s high-desert swing between 100-degree summer afternoons and hard winter mornings. Here’s what we actually see.

  • Lennox Merit Series (13HPX and older 14HPX) reversing valves sticking. When a heat pump can’t shift cleanly between heating and cooling, you’ll notice it heats poorly on a cold morning or blows lukewarm air in July. It’s usually a sticking reversing valve solenoid, not a dead compressor. We test the solenoid coil first and confirm the valve travel before quoting anything bigger.
  • XC Series communicating boards throwing fault codes after voltage dips. The XC16 and XC21 use communicating controls, and brownouts or storm-related power flickers around the Enterprise valley can leave the board locked in a fault state. We pull the stored diagnostics and reset or replace the control board rather than guessing at the whole outdoor unit.
  • Ductless single-zone head drain lines clogging in dry, dusty air. Mini split condensate lines in Enterprise collect fine dust and scale, so the indoor head drips down the wall or stops cooling. We clear and flush the drain, check the float switch, and show you the line before we leave.
  • Multi-zone branch boxes leaking refrigerant at the flare fittings. On Lennox multi-zone systems, flare connections at the branch box work loose over time from expansion and contraction. Low charge makes one zone weak while another runs fine. We leak-check the flares with an electronic detector and torque them to spec instead of just topping off refrigerant, which never fixes the real leak.
  • Scroll compressors failing from a bad run capacitor, not old age. This is the one that gets owners sold a whole new unit they don’t need. We test the capacitor under load before anyone says the word compressor. In plenty of Enterprise heat pumps, a $15 part is the entire problem.
Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Our Lennox Heat Pump & Mini Split Process

Every Lennox job follows the same steps, whether it’s a mini split repair or a full heat pump replacement.

  1. 1
    You call and get a live person. No voicemail maze. We ask what the system is doing and book a time that works for you.
  2. 2
    We listen and run readings first. The person at your door tests pressures, temperatures, capacitor values, and pulls any stored Lennox fault codes. Your system tells us what’s wrong; we just listen.
  3. 3
    You see the numbers before we name a price. We show you the readings and then a written estimate – you see both, in that order.
  4. 4
    We make the parts call honestly. OEM Lennox parts where warranty or fit demands it, quality aftermarket where it doesn’t. We tell you which and why, and we keep the repair warranty-safe.
  5. 5
    We do the repair and re-test. Nothing gets called done until the system holds its numbers through a full heat and cool cycle.
  6. 6
    Cleanup and the guarantee in writing. Every job carries the 90-Day Done Right Promise – if it’s not right, one call brings Ray back, no hassle.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Lennox Heat Pump & Mini Split Costs in Enterprise

Here’s the honest range for the work we do in Enterprise. These are real numbers, not a teaser to get us in the door.

  • Lennox heat pump repair: $150 – $650, depending on whether it’s a capacitor, reversing valve, or control board.
  • Mini split repair: $150 – $650 for the common fixes – drain clogs, flare leaks, low charge.
  • Lennox heat pump installation: $3,500 – $7,500.
  • Multi-zone mini split install: priced within that same $3,500 – $7,500 band for most Enterprise homes, scaled to how many zones you run.
  • Seasonal tune-up: $80 – $200 to keep a heat pump honest before the season turns.

What moves the price: how many zones, line-set length and routing, whether the charge has to be recovered and weighed back in, and whether we’re working with OEM parts. We give free estimates, and there’s no trip charge inside the county. Call (844) 455-2034 and we’ll put real numbers on paper.

Why Enterprise Homeowners Call Ray’s Heating & Air Enterprise for Lennox Work

Because the person who shows up is the same person who shows up next time. Ray’s Heating & Air Enterprise has been locally owned and owner-operated since 2002, and Ray has been to some of these houses four times over the years – it’s been Ray every time. Our technicians have up to 24 years of experience, they’re background-checked and uniformed, and you won’t get a rotating cast who’ve never seen your system. We service all the major brands – Lennox, plus Carrier and Trane – so we’re not going to push a Lennox part just because it says Lennox on the box. You get upfront pricing, the readings before the numbers, and the 90-Day Done Right Promise stamped on the job. That’s why neighbors in Enterprise call us back and pass the number along.

FAQs

Does servicing my Lennox heat pump with an independent company void the warranty? No. As long as the work meets Lennox’s requirements and we use parts that keep the system to spec, using an independent service provider like us doesn’t void your manufacturer warranty. We’ll tell you when an OEM part is the safe call for warranty reasons.

How fast can you get to my Lennox system in Enterprise? Most repair calls are handled the same day, and someone answers the phone around the clock. Call (844) 455-2034 – a live person picks up, not a machine.

Should I repair or replace my older Lennox heat pump? If the repair is a capacitor, drain, or flare fitting and the system is otherwise sound, repair almost always wins. If the compressor or a communicating board is gone on an older Merit unit, we’ll lay out both the repair cost and a replacement in that $3,500 – $7,500 range so you can decide with real numbers in front of you.

Can you get Lennox parts for my mini split or heat pump? Yes. We source both OEM Lennox parts where they matter and quality aftermarket parts where they don’t, and we tell you which you’re getting and why.

Do you install new Lennox heat pumps and mini splits in Enterprise? Yes, including multi-zone ductless systems. Install work is scheduled, load-checked, and quoted with a fixed written price before we start. Call (844) 455-2034 for a free estimate.

Ready to get your Lennox system looked at by someone who knows the equipment and answers his own phone? Call Ray’s Heating & Air Enterprise at (844) 455-2034 for a free estimate – we’ll show you the readings, then the numbers, and get it done right the first time.

Written by the team at Ray’s Heating & Air Enterprise, serving Enterprise and nearby areas.

Need HVAC help nationwide? Licensed & insured · 1-hour response · free estimates
Call (844) 455-2034
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Ray's Heating & Air Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch