A Ray's company - serving Enterprise, NV

Carrier Heating & Furnace in Enterprise, NV

Furnace & heatingFurnace & heating
AC repairAC repair
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Carrier Heating & Furnace in Enterprise: What to Know First

We’re an independent Carrier service provider working in Enterprise, NV, and most Carrier furnace repairs here land between $150 and $700, with same-day turnaround on common failures like ignitors, flame sensors, and bad gas valves. A tune-up runs $80 to $200, and a full Carrier furnace replacement is quoted after we read your system, not before. You’ll see the meter readings and the part numbers before anyone touches a wrench.

Call (844) 455-2034

This page is for the Enterprise homeowner with a Carrier furnace in the garage or closet who wants to know what’s likely wrong, what it should cost, and who’s actually going to show up. That last part matters more than people think. Call (844) 455-2034 and a live person picks up, day or night.

How Carrier Products Fail – and How We Fix Them

Carrier builds a good furnace. But every line has its habits, and after enough winters in Enterprise we know which ones show up on our call sheet. Here are the five we see most.

  • Carrier Comfort series (59SC5, 59TP6): pressure switch and inducer faults. These 80% single-stage units are everywhere in Enterprise tract homes. The draft inducer pulls combustion gas out, and when the pressure switch gets lazy or the inducer wheel loads up with dust, the furnace short-cycles or won’t light at all. We pull the inducer, clean or replace it, and test the switch with a manometer instead of guessing. Nine times out of ten the homeowner was told “bad board” by someone else.
  • Carrier Infinity and Performance series (59MN7, 59TP6): the two-stage gas valve. These modulating and two-stage furnaces are fussy about gas pressure. Enterprise sits at about 5,500 feet, and a Carrier set up for sea-level manifold pressure will run rich, soot the burners, and trip the high-limit. We set manifold pressure to the altitude-corrected spec in the install manual, not the sticker.
  • Carrier 58 series older furnaces: heat exchanger cracks. The 58MCA and 58MSA are workhorses from the 1990s and early 2000s still running in a lot of Enterprise homes. Their secondary heat exchangers can crack and quietly leak carbon monoxide into the airstream. We scope the exchanger on every one of these we touch. This is a safety call, not a sales call, and we show you the camera footage.
  • Hot-surface ignitors: the most common no-heat call. Carrier OEM ignitors (LH33 series and the newer silicon nitride replacements) fail from normal wear and from voltage spikes. A cheap aftermarket ignitor will fit but often runs hotter and dies faster. We stock the OEM-spec part and check the control board’s output before swapping, because a weak board will eat a new ignitor in a season.
  • Flame sensor and grounding faults. A Carrier furnace that lights, runs ten seconds, and shuts off usually has a dirty flame sensor or a bad ground at the unit. In dry Enterprise winters we also see static-related board faults. We clean or replace the sensor, verify microamp readings, and check the grounding before we call it fixed.
Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Our Carrier Heating & Furnace Process

  1. 1
    The call. You reach a live person, not a voicemail maze. We ask what the thermostat is doing, what the furnace is doing, and how old the Carrier is, so we arrive with the right parts for the likely failure.
  2. 2
    Diagnostics first. The tech reads incoming gas pressure, manifold pressure, draft, temperature rise, and flame signal. You get the readings in plain English before any repair is quoted.
  3. 3
    The parts decision. We lay out OEM versus quality aftermarket side by side, with the price and the warranty difference. On Carrier equipment still under the factory parts warranty, we use OEM so the warranty stays intact. On older units, we tell you honestly when an aftermarket part makes more sense than the OEM price.
  4. 4
    The repair. Background-checked, uniformed tech with the right tools and the OEM-spec part. No rotating crew that’s never seen your system.
  5. 5
    The test. We run a full heat cycle, re-check temperature rise and flame signal, and confirm the furnace cycles cleanly. You watch if you want to.
  6. 6
    The guarantee. Every Carrier job carries our 90-Day Done Right Promise in writing. If it’s not right, one call brings Ray back.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Carrier Heating & Furnace Costs in Enterprise

Real numbers, from jobs we’ve run in Enterprise. Your exact price depends on the part and the diagnosis, but these ranges hold.

Carrier service Typical range in Enterprise
Furnace repair (ignitor, sensor, gas valve, inducer) $150 – $700
Furnace tune-up and safety check $80 – $200
Heat exchanger inspection with camera Included in diagnostics
Full Carrier furnace replacement Quoted after load calculation

What moves the price: OEM versus aftermarket parts, whether the control board is also failing, and access to the unit. A furnace in a tight closet takes longer than one in open garage space. You’ll see a written estimate before we start. Estimates are free, and a free second opinion on any written estimate you already have.

Why Enterprise Homeowners Call Ray’s Heating & Air Enterprise for Carrier Work

Because the person who shows up is the person who shows up next time. No dispatch, no rotating crew, no stranger who’s never seen your Carrier. Ray Alvarez answers his own phone at two in the morning, and his name, address, and license number are published so you can check before you call. That’s how we’ve stayed locally owned and owner-operated since 2002.

We also carry plenty of non-Carrier experience, which matters when a part is backordered or a repair isn’t worth it. We service Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard too, so we can give you an honest repair-versus-replace comparison across brands. The 90-Day Done Right Promise is stamped on every heating job. Uniformed, background-checked techs, and the same face on your next carrier call. Enterprise deserves that.

FAQs

Need HVAC help nationwide? Licensed & insured · 1-hour response · free estimates
Call (844) 455-2034
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Ray's Heating & Air Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch